99242 Medicaid reimbursement rate by state (2026)

• Order. States are listed from the highest published rate to the lowest. No single unit is shared by 8 or more states for 99242, so the order is by published amount and is not a like-for-like rank.
• Medicaid rate. The most the state's fee-for-service program pays for one unit, as published. 28 of the 35 states list more than one rate for 99242, by modifier, provider type or setting; the table shows the one that matches the provider level and setting used across states, without add-ons.
• Unit. Of the 35 states, 1 publish 99242 per unit, and 34 schedules print no unit at all (a flat amount per service).
• Per hour. 99242 is not billed in time units in these states, so no hourly figure is shown.
• Managed-care plans. The rule the state sets for its plans on this rate. What each rule means is explained below.
• % of Medicare. No Medicare physician fee schedule amount is on file for 99242, so there is no percentage.
• Source and date. Each Source link opens the state's own document; “since” is the date the rate took effect.

Published rates for 99242 run from $33.92 in Ohio to $141.35 in Alabama, a 4.2x gap in the same unit. Half the states pay more than the median of $62.49 and half pay less. The usual reasons for a spread like this in physician & professional rates:

• Each state sets its own physician conversion factor or fee for every code, and many update them on a state budget cycle rather than on Medicare's calendar.
• Modifiers such as professional or technical component, bilateral, multiple procedure and assistant at surgery change the amount paid, and states apply them with their own percentages.
• Some states pay physician services as a percentage of the Medicare fee schedule; others keep a schedule of their own that may not have been rebased for years.

Timing matters too. 17 states set the current rate for 99242 in 2026 or later, while 8 states still pay a rate that took effect in 2022 or earlier. A state that has not updated its rate in years will drift down the ranking as others raise theirs.

No managed-care plan publishes what it pays for 99242. What is public is the rule each state's plan contracts set, and that rule decides how much the published rate matters when you contract with a plan.

In 8 states, the published rate binds plans: a floor, a pass-through or a state-set rate. In 18 states, plans negotiate and the published rate is a benchmark or out-of-network default. The rule for the remaining 9 states is not classified yet.

• Plans negotiate; the published rate applies out of network (18 states). In-network rates can be above or below the published rate. The published rate is the benchmark both sides know, and the fallback if no contract is signed.
• Plans must pay at least the published rate (8 states). The published rate is your floor. Negotiate up from it, and if a plan pays less, the contract provision is the basis for a payment dispute.

Plan-negotiated rates are never estimated here. To see the rule and its citation for a particular state, open that state's managed-care page, for example Alabama managed care.

99242 is a CPT evaluation and management code in the physician & professional line, billed mostly by physicians, nurse practitioners, physician assistants and other licensed practitioners. Evaluation and management codes are billed once per visit. The code itself sets the level of the visit, so there is no time unit to multiply, and the setting (office, hospital, facility) decides which code applies.

Where a state publishes separate facility and non-facility amounts, the non-facility (office) amount is usually higher because the practice carries the overhead. Practitioners who are not physicians are often paid a reduced percentage of the published amount, so check the schedule for the reduction that applies to your provider type.

Before billing, confirm the rate, unit and any modifier with the state's current schedule or the plan: the amounts here are as published, not a guarantee of payment.