99292 Medicaid reimbursement rate by state (2026)
Physician and practitioner services (fee schedule). Medicaid pays a median of $97.51 for 99292 across 48 states, from $23.40 in District of Columbia to $238.67 in Alaska.
- States publishing
- 48
- National median
- $97.51units vary by state
- Lowest
- $23.40District of Columbia
- Highest
- $238.67Alaska
What does Medicaid pay for 99292?
48 state Medicaid programs publish a fee-for-service rate for 99292. The national median is $97.51 (units differ between states). Alaska pays the most, $238.67, and District of Columbia the least, $23.40, a 10.2x spread.
Medicare (non-facility, 2026 physician fee schedule): $123.01–$171.39 depending on the state's Medicare locality.
99292 rate by state: highest, middle and lowest
One like-for-like fee-for-service rate per state, ranked. The workspace lists all 48 states with every variant, modifier and effective date.
How to read this table
- Order. States are listed from the highest published rate to the lowest. No single unit is shared by 8 or more states for 99292, so the order is by published amount and is not a like-for-like rank.
- Medicaid rate. The most the state's fee-for-service program pays for one unit, as published. 40 of the 48 states list more than one rate for 99292, by modifier, provider type or setting; the table shows the one that matches the provider level and setting used across states, without add-ons.
- Unit. Of the 48 states, 1 publish 99292 per unit, and 47 schedules print no unit at all (a flat amount per service).
- Per hour. 99292 is not billed in time units in these states, so no hourly figure is shown.
- Managed-care plans. The rule the state sets for its plans on this rate. What each rule means is explained below.
- % of Medicare. Medicare amounts exist for 99292, but no state's Medicaid unit matches Medicare's billing unit closely enough to compute a percentage.
- Source and date. Each Source link opens the state's own document; “since” is the date the rate took effect.
Why 99292 rates differ between states
Published rates for 99292 run from $23.40 in District of Columbia to $238.67 in Alaska, a 10.2x gap in the same unit. Half the states pay more than the median of $97.51 and half pay less. The usual reasons for a spread like this in physician & professional rates:
- Primary-care and pediatric add-ons, enhanced rates for certain specialties and targeted increases for access problems change individual codes without moving the rest of the schedule.
- Many schedules pay differently by place of service (office versus facility) and by practitioner, and nurse practitioners and physician assistants are often paid a percentage of the physician amount.
- Some states pay physician services as a percentage of the Medicare fee schedule; others keep a schedule of their own that may not have been rebased for years.
Timing matters too. 30 states set the current rate for 99292 in 2026 or later, while 9 states still pay a rate that took effect in 2022 or earlier. A state that has not updated its rate in years will drift down the ranking as others raise theirs.
What managed-care plans pay for 99292
Most Medicaid members are in managed-care plans, and plans don't publish their provider fee schedules. For 99292, the public signal is the rule each state sets for its plans, recorded on each rate above.
In 14 states, the published rate binds plans: a floor, a pass-through or a state-set rate. In 21 states, plans negotiate and the published rate is a benchmark or out-of-network default. The rule for the remaining 13 states is not classified yet.
- Plans negotiate; the published rate applies out of network (21 states). In-network rates can be above or below the published rate. The published rate is the benchmark both sides know, and the fallback if no contract is signed.
- Plans must pay at least the published rate (14 states). The published rate is your floor. Negotiate up from it, and if a plan pays less, the contract provision is the basis for a payment dispute.
Plan-negotiated rates are never estimated here. To see the rule and its citation for a particular state, open that state's managed-care page, for example Alaska managed care.
Units and billing for 99292
99292 is a CPT evaluation and management code in the physician & professional line, billed mostly by physicians, nurse practitioners, physician assistants and other licensed practitioners. Evaluation and management codes are billed once per visit. The code itself sets the level of the visit, so there is no time unit to multiply, and the setting (office, hospital, facility) decides which code applies.
Where a state publishes separate facility and non-facility amounts, the non-facility (office) amount is usually higher because the practice carries the overhead. Physician-fee-schedule codes are billed per service: one unit is one occurrence unless the code itself is defined by time or quantity.
Medicare's 2026 physician fee schedule pays $123.01–$171.39 for 99292 (non-facility), depending on the Medicare locality. That is a useful reference point, but Medicare and Medicaid can define the unit differently, so compare only where the units match.
Before billing, confirm the rate, unit and any modifier with the state's current schedule or the plan: the amounts here are as published, not a guarantee of payment.
Frequently asked questions
What does Medicaid pay for 99292?
It depends on the state. Of the 48 states with a published fee-for-service rate, the median is $97.51. Alaska pays the most ($238.67) and District of Columbia the least ($23.40).
Which state pays the highest Medicaid rate for 99292?
Alaska, at $238.67, effective 2026-07-01.
Which state pays the lowest Medicaid rate for 99292?
District of Columbia, at $23.40, effective 2018-04-01.
What unit is 99292 billed in?
Of the 48 states, 1 publish 99292 per unit, and 47 schedules print no unit at all (a flat amount per service).
Do managed-care plans pay the same rate for 99292?
Not necessarily. In 14 states, the published rate binds plans: a floor, a pass-through or a state-set rate. In 21 states, plans negotiate and the published rate is a benchmark or out-of-network default. The rule for the remaining 13 states is not classified yet. Each rule is cited to the plan contract, statute or notice in the workspace.