G9919 Medicaid reimbursement rate by state (2026)
Screening performed and positive and provision of.... Medicaid pays a median of $29.00 for G9919 across 5 states, from $13.49 in California to $50.00 in Missouri.
- States publishing
- 5
- National median
- $29.00units vary by state
- Lowest
- $13.49California
- Highest
- $50.00Missouri
What does Medicaid pay for G9919?
5 state Medicaid programs publish a fee-for-service rate for G9919. The national median is $29.00 (units differ between states). Missouri pays the most, $50.00, and California the least, $13.49, a 3.7x spread.
G9919 rate by state: highest, middle and lowest
One like-for-like fee-for-service rate per state, ranked. The workspace lists all 5 states with every variant, modifier and effective date.
How to read this table
- Order. States are listed from the highest published rate to the lowest. No single unit is shared by 8 or more states for G9919, so the order is by published amount and is not a like-for-like rank.
- Medicaid rate. The most the state's fee-for-service program pays for one unit, as published. 4 of the 5 states list more than one rate for G9919, by modifier, provider type or setting; the table shows the one that matches the provider level and setting used across states, without add-ons.
- Unit. Of the 5 states, 1 publish G9919 per unit, and 4 schedules print no unit at all (a flat amount per service).
- Per hour. G9919 is not billed in time units in these states, so no hourly figure is shown.
- Managed-care plans. The rule the state sets for its plans on this rate. What each rule means is explained below.
- % of Medicare. No Medicare physician fee schedule amount is on file for G9919, so there is no percentage.
- Source and date. Each Source link opens the state's own document; “since” is the date the rate took effect.
Why G9919 rates differ between states
Published rates for G9919 run from $13.49 in California to $50.00 in Missouri, a 3.7x gap in the same unit. Half the states pay more than the median of $29.00 and half pay less. The usual reasons for a spread like this in physician & professional rates:
- Many schedules pay differently by place of service (office versus facility) and by practitioner, and nurse practitioners and physician assistants are often paid a percentage of the physician amount.
- Each state sets its own physician conversion factor or fee for every code, and many update them on a state budget cycle rather than on Medicare's calendar.
- Primary-care and pediatric add-ons, enhanced rates for certain specialties and targeted increases for access problems change individual codes without moving the rest of the schedule.
Timing matters too. 1 state set the current rate for G9919 in 2026 or later. A state that has not updated its rate in years will drift down the ranking as others raise theirs.
What managed-care plans pay for G9919
No managed-care plan publishes what it pays for G9919. What is public is the rule each state's plan contracts set, and that rule decides how much the published rate matters when you contract with a plan.
In 1 state, the published rate binds plans: a floor, a pass-through or a state-set rate. In 1 state, plans negotiate and the published rate is a benchmark or out-of-network default. In 1 state, the service is paid outside the plans or through a state-directed payment. The rule for the remaining 2 states is not classified yet.
- Plans must pay at least the published rate (1 state). The published rate is your floor. Negotiate up from it, and if a plan pays less, the contract provision is the basis for a payment dispute.
- Plans negotiate; the published rate applies out of network (1 state). In-network rates can be above or below the published rate. The published rate is the benchmark both sides know, and the fallback if no contract is signed.
- Paid by the state, outside the plans (1 state). Bill the state's Medicaid program, not the plan, at the published rate. There is no plan contract to negotiate for this service.
Plan-negotiated rates are never estimated here. To see the rule and its citation for a particular state, open that state's managed-care page, for example Missouri managed care.
Units and billing for G9919
G9919 is a HCPCS Level II professional services code in the physician & professional line, billed mostly by physicians, nurse practitioners, physician assistants and other licensed practitioners. G codes describe professional services and procedures that have no CPT code, or that payers define more narrowly. Many are timed, so check the unit before comparing.
Physician-fee-schedule codes are billed per service: one unit is one occurrence unless the code itself is defined by time or quantity. Practitioners who are not physicians are often paid a reduced percentage of the published amount, so check the schedule for the reduction that applies to your provider type.
Before billing, confirm the rate, unit and any modifier with the state's current schedule or the plan: the amounts here are as published, not a guarantee of payment.
Frequently asked questions
What does Medicaid pay for G9919?
It depends on the state. Of the 5 states with a published fee-for-service rate, the median is $29.00. Missouri pays the most ($50.00) and California the least ($13.49).
Which state pays the highest Medicaid rate for G9919?
Missouri, at $50.00, effective 2024-05-08.
Which state pays the lowest Medicaid rate for G9919?
California, at $13.49, effective 2026-10-01.
What unit is G9919 billed in?
Of the 5 states, 1 publish G9919 per unit, and 4 schedules print no unit at all (a flat amount per service).
Do managed-care plans pay the same rate for G9919?
Not necessarily. In 1 state, the published rate binds plans: a floor, a pass-through or a state-set rate. In 1 state, plans negotiate and the published rate is a benchmark or out-of-network default. In 1 state, the service is paid outside the plans or through a state-directed payment. The rule for the remaining 2 states is not classified yet. Each rule is cited to the plan contract, statute or notice in the workspace.