47802 Medicaid reimbursement rate by state (2026)

• Order. States are listed from the highest published rate to the lowest. No single unit is shared by 8 or more states for 47802, so the order is by published amount and is not a like-for-like rank.
• Medicaid rate. The most the state's fee-for-service program pays for one unit, as published. 1 of the 5 states list more than one rate for 47802, by modifier, provider type or setting; the table shows the one that matches the provider level and setting used across states, without add-ons.
• Unit. None of the 5 schedules prints a separate unit for 47802, so each amount is a flat payment for one service as the code defines it.
• Per hour. 47802 is not billed in time units in these states, so no hourly figure is shown.
• Managed-care plans. The rule the state sets for its plans on this rate. What each rule means is explained below.
• % of Medicare. No Medicare physician fee schedule amount is on file for 47802, so there is no percentage.
• Source and date. Each Source link opens the state's own document; “since” is the date the rate took effect.

Published rates for 47802 run from $763.53 in Colorado to $2,235.79 in New Mexico, a 2.9x gap in the same unit. Half the states pay more than the median of $974.26 and half pay less. The usual reasons for a spread like this in physician & professional rates:

• Some states pay physician services as a percentage of the Medicare fee schedule; others keep a schedule of their own that may not have been rebased for years.
• Each state sets its own physician conversion factor or fee for every code, and many update them on a state budget cycle rather than on Medicare's calendar.
• Modifiers such as professional or technical component, bilateral, multiple procedure and assistant at surgery change the amount paid, and states apply them with their own percentages.

Timing matters too. 1 state set the current rate for 47802 in 2026 or later, while 1 state still pay a rate that took effect in 2022 or earlier. A state that has not updated its rate in years will drift down the ranking as others raise theirs.

What a plan pays for 47802 is negotiated privately, but the state decides how much room there is to negotiate. Here is how the rules break down across the 5 states.

In 1 state, the published rate binds plans: a floor, a pass-through or a state-set rate. In 4 states, plans negotiate and the published rate is a benchmark or out-of-network default.

• Plans negotiate; the published rate applies out of network (4 states). In-network rates can be above or below the published rate. The published rate is the benchmark both sides know, and the fallback if no contract is signed.
• Plans must pay at least the published rate (1 state). The published rate is your floor. Negotiate up from it, and if a plan pays less, the contract provision is the basis for a payment dispute.

Plan-negotiated rates are never estimated here. To see the rule and its citation for a particular state, open that state's managed-care page, for example New Mexico managed care.

47802 is a CPT surgery code in the physician & professional line, billed mostly by physicians, nurse practitioners, physician assistants and other licensed practitioners. Surgical codes are paid once per procedure. The fee can include a global period of related care before and after the procedure, and modifiers for multiple, bilateral or assistant procedures raise or reduce what is actually paid.

Physician-fee-schedule codes are billed per service: one unit is one occurrence unless the code itself is defined by time or quantity. Where a state publishes separate facility and non-facility amounts, the non-facility (office) amount is usually higher because the practice carries the overhead.

Before billing, confirm the rate, unit and any modifier with the state's current schedule or the plan: the amounts here are as published, not a guarantee of payment.