S0316 Medicaid reimbursement rate by state (2026)
Disease management program, follow-up/reassessment. Medicaid pays a median of $42.79 for S0316 across 5 states, from $14.09 in South Carolina to $170.00 in Michigan.
- States publishing
- 5
- National median
- $42.79units vary by state
- Lowest
- $14.09South Carolina
- Highest
- $170.00Michigan
What does Medicaid pay for S0316?
5 state Medicaid programs publish a fee-for-service rate for S0316. The national median is $42.79 (units differ between states). Michigan pays the most, $170.00, and South Carolina the least, $14.09, a 12.1x spread.
S0316 rate by state: highest, middle and lowest
One like-for-like fee-for-service rate per state, ranked. The workspace lists all 5 states with every variant, modifier and effective date.
How to read this table
- Order. States are listed from the highest published rate to the lowest. No single unit is shared by 8 or more states for S0316, so the order is by published amount and is not a like-for-like rank.
- Medicaid rate. The most the state's fee-for-service program pays for one unit, as published. 4 of the 5 states list more than one rate for S0316, by modifier, provider type or setting; the table shows the one that matches the provider level and setting used across states, without add-ons.
- Unit. None of the 5 schedules prints a separate unit for S0316, so each amount is a flat payment for one service as the code defines it.
- Per hour. S0316 is not billed in time units in these states, so no hourly figure is shown.
- Managed-care plans. The rule the state sets for its plans on this rate. What each rule means is explained below.
- % of Medicare. No Medicare physician fee schedule amount is on file for S0316, so there is no percentage.
- Source and date. Each Source link opens the state's own document; “since” is the date the rate took effect.
Why S0316 rates differ between states
Published rates for S0316 run from $14.09 in South Carolina to $170.00 in Michigan, a 12.1x gap in the same unit. Half the states pay more than the median of $42.79 and half pay less. The usual reasons for a spread like this in physician & professional rates:
- Modifiers such as professional or technical component, bilateral, multiple procedure and assistant at surgery change the amount paid, and states apply them with their own percentages.
- Many schedules pay differently by place of service (office versus facility) and by practitioner, and nurse practitioners and physician assistants are often paid a percentage of the physician amount.
- Some states pay physician services as a percentage of the Medicare fee schedule; others keep a schedule of their own that may not have been rebased for years.
Timing matters too. None of the states changed its rate for S0316 in 2026, while 5 states still pay a rate that took effect in 2022 or earlier. A state that has not updated its rate in years will drift down the ranking as others raise theirs.
What managed-care plans pay for S0316
What a plan pays for S0316 is negotiated privately, but the state decides how much room there is to negotiate. Here is how the rules break down across the 5 states.
In 2 states, the published rate binds plans: a floor, a pass-through or a state-set rate. In 3 states, plans negotiate and the published rate is a benchmark or out-of-network default.
- Plans negotiate; the published rate applies out of network (3 states). In-network rates can be above or below the published rate. The published rate is the benchmark both sides know, and the fallback if no contract is signed.
- Plans must pay at least the published rate (2 states). The published rate is your floor. Negotiate up from it, and if a plan pays less, the contract provision is the basis for a payment dispute.
Plan-negotiated rates are never estimated here. To see the rule and its citation for a particular state, open that state's managed-care page, for example Michigan managed care.
Units and billing for S0316
S0316 is a HCPCS Level II temporary national code in the physician & professional line, billed mostly by physicians, nurse practitioners, physician assistants and other licensed practitioners. S codes were created for private payers and are widely used by Medicaid programs for services Medicare does not cover, such as home nursing and home infusion. Units range from 15 minutes to a day.
Physician-fee-schedule codes are billed per service: one unit is one occurrence unless the code itself is defined by time or quantity. Where a state publishes separate facility and non-facility amounts, the non-facility (office) amount is usually higher because the practice carries the overhead.
Before billing, confirm the rate, unit and any modifier with the state's current schedule or the plan: the amounts here are as published, not a guarantee of payment.
Frequently asked questions
What does Medicaid pay for S0316?
It depends on the state. Of the 5 states with a published fee-for-service rate, the median is $42.79. Michigan pays the most ($170.00) and South Carolina the least ($14.09).
Which state pays the highest Medicaid rate for S0316?
Michigan, at $170.00, effective 2020-03-01.
Which state pays the lowest Medicaid rate for S0316?
South Carolina, at $14.09, effective 2014-08-01.
What unit is S0316 billed in?
None of the 5 schedules prints a separate unit for S0316, so each amount is a flat payment for one service as the code defines it.
Do managed-care plans pay the same rate for S0316?
Not necessarily. In 2 states, the published rate binds plans: a floor, a pass-through or a state-set rate. In 3 states, plans negotiate and the published rate is a benchmark or out-of-network default. Each rule is cited to the plan contract, statute or notice in the workspace.